Toyota Camry

1992-1997 of release

Repair and operation of the car

Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
- 4. Capital repairs of engines
   4.2. General information
   4.3. Check of a compression
   4.4. Recommendations about removal of the engine
   + 4.5. Removal and installation of the engine
   4.6. Sequence of dismantling of the engine
   4.7. Dismantling of a head of the block of cylinders
   + 4.8. Cleaning and survey of a head of the block of cylinders
   4.9. Assembly of a head of the block of cylinders
   4.10. Removal of pistons with rods
   4.11. Removal of a bent shaft
   + 4.12. Block of cylinders of the engine
   4.13. Pistons and rods
   4.14. Bent shaft
   + 4.15. Survey and choice of radical and conrod bearings
   4.16. Control of a side play of assembly of the balance weight (engine 5S-FE)
   4.17. Engine balance of assembly at capital repairs
   4.18. Installation of piston rings
   + 4.19. Installation of a bent shaft and check of working gaps of bearings
   4.20. Installation of a back sealing ring of a bent shaft
   4.21. Installation of pistons and rods, check of working gaps of bearings
   4.22. Installation of assembly of the balance weight (engine 5S-FE)
   4.23. Start of the engine after capital repairs
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment

4.18. Installation of piston rings

1. Before installation of new piston rings check a gap in the lock of a piston ring. 2. Arrange pistons and piston rings according to cylinders in which they will work.
3. Install the top sealing ring in the first cylinder and the bottom of the piston push it in the cylinder to the cylinder basis.
4. Using the probe, measure a gap in the ring lock.
5. Repeat process of measurement with the ring established in the top part of the cylinder and compare results of measurement to technical requirements.
6. Repeat operation of check for each ring in the first cylinder, then for rings in other cylinders.
7. Install piston rings on pistons in the same way, as well as at removal.
8. First of all the oil scraper ring which consists of three separate elements is established. Establish a dilator of an oil scraper ring in a piston flute. 9. Then consistently establish the top and lower oil scraper rings.
10. Establish a compression ring No. 2 so that the tag at an end face of a ring was directed up. Do not mix the first and second compression rings as they have various profile.
11. After installation of piston rings on the piston check ease of movement of a piston ring in a piston flute.