Repair and operation of the Toyota Camry car - 8.6.1. Replacement//Toyota Camry of 1992-1997 /

Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
- 8. Decrease in toxicity
   8.2. General information
   8.3. System of electronic control (TCCS)
   8.4. System of self-diagnostics
   + 8.5. Sensors
   - 8.6. Induction system of air supply in the engine (ACIS)
      8.6.1. Replacement
   8.7. System of catching of vapors of fuel (EVAP)
   + 8.8. System of repeated combustion of exhaust gases (EGR)
   8.9. System of ventilation of a case (PCV)
   8.10. Catalyst
   8.11. Codes of malfunctions
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



8.6.1. Replacement

GENERAL INFORMATION

Preventions

In the presence in the code radio receiver against theft, before an accumulator detachment, check that you have connection codes.

On models since 1993 the system of the airbag of safety is disconnected if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for maintenance of system.


Details of the adjusting valve of induction system of air supply
 

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. On the engine 3VZ-FE disconnect the electric socket from a fuel nozzle of cold start and a fuel supply hose.
3. Disconnect vacuum hoses from the vacuum amplifier of brakes, the valve of the mode of idling of air conditioning system and the adjusting valve.

4. Unscrew bolts and remove assembly of the adjusting valve from the air inlet camera.

5. Clear the interfaced surfaces of the camera of a vozdukhozaborna and cases of the adjusting valve.
6. Installation is made in the sequence, the return to removal. At the same time it is necessary to use new laying.