Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
- 15. Electric equipment
   15.2. General information
   15.3. Electric chains
   + 15.4. Detection of not closed chain
   15.5. Safety locks
   15.6. Relay
   + 15.7. Multipurpose switches of a steering column
   + 15.8. Ignition lock
   15.9. Switch of a heater of back glass
   15:10. Check of a heater of back glass
   15:11. Radio receiver
   15:12. Loudspeakers
   15:13. Antenna
   15:14. Replacement of bulbs of headlights
   15:15. Adjustment of light of headlights
   15:16. Headlight
   + 15:17. Replacement of bulbs of an incandescence
   + 15:18. Screen wiper engine
   15:19. Combination of devices
   15:20. Sound signal
   15:21. System cruise control
   15:22. Window regulators with the electric drive
   15:23. System of the central blocking of locks
   15:24. Rear-view mirrors with the electric drive
   15:25. Safety airbag
   + 15:26. Schemes of electric equipment




15.6. Relay

GENERAL INFORMATION

Arrangement of blocks of the relay on the car
1 – block of the relay No. 7;
2 – connecting block No. 2;
3 – block of the relay No. 5;
4-connecting block No. 1;
5 – block of the relay No. 4;
6 – block of the relay No. 6

Use of a steel core for installation of the relay of an overload in a starting position

 

The relay is electronically the operated switch which is usually used as follows:

– the relay can switch big currents remotely from a chain in which this current flows, allowing to use thinner wires and contacts of switches;
– the relay can have more than one managing director of an entrance unlike the mechanical switch;
– the relay can perform function of the timer, for example, to set an interval of work of screen wipers.

For protection of some electric chains (power windows, locks of doors, headlights) the overload relay is used. At considerable excess of the consumed current, the automatic relay of an overload for a short time will disconnect a power-supply circuit of the consumer, however for maintenance some relays of an overload need to be turned on manually. For this purpose remove the relay of an overload and from contacts insert a steel core into an opening of repeated installation and press a clamp before click (see rice. Use of a steel core for installation of the relay of an overload in a starting position).

If the system operated by the relay fails, and a cause of defect, perhaps, the relay is, listen to operation of the relay at the included system. If the relay regularly works, then you have to hear click at its inclusion. If the relay is serviceable, then the cause of defect is concluded in elements or the connecting wires. If the relay does not work, it means that it does not receive the main power supply or the operating impulse, or the relay is faulty.