Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
- 15. Electric equipment
   15.2. General information
   15.3. Electric chains
   + 15.4. Detection of not closed chain
   15.5. Safety locks
   15.6. Relay
   + 15.7. Multipurpose switches of a steering column
   + 15.8. Ignition lock
   15.9. Switch of a heater of back glass
   15:10. Check of a heater of back glass
   15:11. Radio receiver
   15:12. Loudspeakers
   15:13. Antenna
   15:14. Replacement of bulbs of headlights
   15:15. Adjustment of light of headlights
   15:16. Headlight
   + 15:17. Replacement of bulbs of an incandescence
   + 15:18. Screen wiper engine
   15:19. Combination of devices
   15:20. Sound signal
   15:21. System cruise control
   15:22. Window regulators with the electric drive
   15:23. System of the central blocking of locks
   15:24. Rear-view mirrors with the electric drive
   15:25. Safety airbag
   + 15:26. Schemes of electric equipment




15:11. Radio receiver

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
Preventions

In the presence in the code radio receiver against theft, before a detachment of the accumulator check that you have connection codes.

On models since 1993 the system of the airbag of safety is disconnected if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for maintenance of system.


2. Remove the decorative panel located around the radio receiver.
3. Unscrew screws of fastening of the radio receiver.
4. Extend the radio receiver from a nest, disconnect from it the electric socket and the antenna and take the radio receiver from the car.
5. Installation is made in the sequence, the return to removal.