Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
- 13. Suspension bracket
   13.2. General information
   - 13.3. Forward stabilizer of cross stability
      13.3.2. Installation
   + 13.4. The lobby is resistant
   13.5. Repair of a forward rack
   + 13.6. Lower lever of a forward suspension bracket
   13.7. Replacement of the lower hinge of a forward suspension bracket
   + 13.8. Rotary fist
   13.9. Back stabilizer of cross stability
   + 13:10. Rack of a back suspension bracket
   13:11. Longitudinal draft of a back suspension bracket
   + 13:12. Levers of a back suspension bracket
   + 13:13. Nave of a back suspension bracket
   + 13:14. Fastener of a back nave
   + 13:15. Steering wheel
   + 13:16. Tips of steering draft
   13:17. Replacement of protective covers of steering transfer
   + 13:18. Steering transfer
   + 13:19. Pump of the amplifier of steering
   13:20. Removal of air from system of steering with the amplifier
   + 13:21. Wheels and tires
   13:22. Angles of installation of wheels
+ 14. Body
+ 15. Electric equipment




13.3. Forward stabilizer of cross stability

13.3.1. Removal

PERFORMANCE ORDER
1. Lift a forward part of the car and record on supports. Remove forward wheels.
2. Unscrew three bolts and remove protection of the right and left forward wings.
3. Unscrew drafts of the stabilizer from the lower levers of a forward suspension bracket.
4. Unscrew drafts of the stabilizer from the stabilizer of cross stability. 5. Unscrew bolts of fastening of the clips fixing the stabilizer of cross resistance to the lower frame.
6. Remove a reception exhaust pipe.
7. Unscrew bolts of fastening of steering transfer.
8. Remove steering transfer and take the stabilizer of cross stability from under the left wing.
9. Check the stabilizer for lack of wear and mechanical damages. Pay special attention to a condition of plugs of installation of the stabilizer.

10. Check a condition of the spherical hinge of draft of the stabilizer. For check of a condition of the spherical hinge establish draft of the stabilizer in a vice, screw a nut on a pin of the spherical hinge and, using a dynamometer key, turn 4 times a pin of the spherical hinge and, turning the 5th time a pin of the spherical hinge, define torque which needs to be put for a provorachivaniye of a pin of the spherical hinge. Torque size for a provorachivaniye of a pin of the spherical hinge has to make from 0,5 to 10 Nanometers. Otherwise replace draft of the stabilizer.