Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
- 7. System of ignition
   7.2. Accumulator
   + 7.3. System of ignition
   + 7.4. Check of system of ignition
   + 7.5. Ignition coil
   + 7.6. Ignition distributor
   7.7. Check and adjustment of a corner of an advancing of ignition
   7.8. Block of ignition (switchboard)
   + 7.9. Sensor of impulses
   7.10. System of charging
   7.11. Generator
   7.12. Check and replacement of components of the generator
   7.13. System of start of the engine
   7.14. Starter
   7.15. Traction relay
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment




7.11. Generator

GENERAL INFORMATION

Preventions

In the presence in the code radio receiver against theft, before an accumulator detachment, check that you have connection codes.

On models since 1993 the system of the airbag of safety is disconnected if the accumulator is disconnected for long term. If a control lamp of a pillow безопаснос ти it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for maintenance of system.


Contact connection F generators with a weight when checking operability of the generator

 

The scheme of connection of measuring devices for check of operability of the generator

 

Elements of fastening of the generator of the four-cylinder engine

 
1 – hinged bolt;
2 – adjusting bolt;
3 – electric wire;
4 – electric socket;
5 – generator;
6 – driving belt

Elements of fastening of the generator on the six-cylinder engine

 
1 – tightening bolt;
2 – hinged bolt;
3 – washer;
4 – electric wire;
5 – electric socket;
6 – adjusting bolt;
7 – generator;
8 – driving belt

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Disconnect electric wires from the generator.

3. Weaken fastening adjusting and hinged bolts of the generator and take off a driving belt.

4. Unscrew two bolts of fastening of an arm of the generator and remove the generator together with an arm.
5. Installation is made in the sequence, the return to removal.
6. After installation of the generator adjust a tension of a driving belt.