Toyota Camry

1992-1997 of release

Repair and operation of the car


Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
- 14. Body
   14.1.1. Security measures when carrying out welding works
   + 14.2. Care of a body
   + 14.3. Care of an upholstery and rugs
   + 14.4. Repair of insignificant damages of a body
   14.5. Repair of strong damages of a body
   + 14.6. Cowl
   14.7. Trunk lid
   14.8. Back door
   + 14.9. Replacement of racks of support
   14:10. Door upholstery
   + 14:11. Doors
   + 14:12. Lock, cylinder of the lock and handle of opening of a door
   14:13. Door glass
   14:14. Window regulator
   14:15. Front bumper
   14:16. Rear bumper
   14:17. External rear-view mirrors
   + 14:18. Seats
   14:19. Decorative overlay of a combination of devices
   14:20. Casings of a steering column
   14:21. Central console
   14:22. Ware box
   14:23. Check of a condition of seat belts
   14:24. Front grille
   14:25. Engine mudguard
+ 15. Electric equipment




14:10. Door upholstery
PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Open a forward door. Using a screw-driver edge as the lever, remove a decorative overlay of the internal handle of opening of a door.
3. On models with a manual window regulator completely close a window and note a window regulator handle arrangement. Release a bracket of fastening and remove the handle. The bracket of an osvobozhd etsyatsya if to insert pure fabric between the handle and an upholstery of a door and, stretching fabric opposite to the ends of a bracket, hook on a bracket and release it. At the same time it is necessary to pull the handle on himself that she after release of a bracket acted from window regulator shlits.
4. Take the clamps of fastening of an upholstery of a door to a door located on door upholstery perimeter.
5. Unscrew the screws fixing a door armrest.
6. Using the screw-driver with a wide edge, separate a door upholstery from a door.
7. After separation of an upholstery of a door from a door disconnect electric sockets and remove a door upholstery from the car.
8. If it is necessary, remove a protective film from a door.
9. Installation is made in the sequence, the return to removal.