Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
- 5. Cooling and heating
   5.2. General information
   5.3. Antifreeze
   5.4. Cooling system hoses
   + 5.5. Check and replacement of the thermostat
   + 5.6. Check and replacement of the fan of a radiator and relay
   - 5.7. The radiator fan (the V6 models from 1992 to 1994)
      5.7.1. Check
      5.7.2. Replacement
   + 5.8. Radiator
   5.9. Broad tank
   + 5.10. Water pump
   + 5.11. Sensor of temperature of cooling liquid
   5.12. Heater fan
   5.13. Heater fan resistor
   5.14. Heater radiator
   + 5.15. Control panel of a heater
   5.16. Air conditioning system
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment




5.7.1. Check

GENERAL INFORMATION

Arrangement of the control unit of the fan of a radiator, contacts on the electric socket

 


PERFORMANCE ORDER
1. Connect an additional wire contacts of E1 and OR1 of the electric socket. At the same time the fan of a radiator has to rotate with a speed about 1100 rpm.
2. The control unit of the fan of a radiator is located under a ware box. For check of electric chains of control of the fan of a radiator remove the lower casing of the dashboard and a ware box and disconnect the electric socket from the ECU block.
3. Check electric chains according to the table Check of Electric Chains.
4. For check of the sensor of temperature of cooling liquid disconnect the electric socket from the sensor and remove the sensor. Connect an ohmmeter to contacts of the sensor, install the sensor in a container with hot water and measure its resistance. Sensor resistance at the water temperature of 80 °C has to be in limits of 1480-1580 Ohms.
5. For check of the electromagnetic valve disconnect from it the electric socket and check resistance of a winding of the electromagnetic valve which has to make 7,6–8 Ohms at 25 °C.

Check of electric chains

Control
Connections of a tester
Condition
Value
Tension
1 – Weight
Ignition is included
Accumulator tension
Soprotivl.
2–3
Electromagnetic valve cold (25 C)
7,6 – 8,0 Ohms
Connection
4 – Weight
The butterfly valve is open
Are closed
Connection
5 – Weight
The butterfly valve is closed
Are not closed
Connection
8 – Weight
Pressure А/С socket is disconnected
Are not closed
Pressure А/С socket is connected
Are closed
Soprotivl.
9–10
Temperature of cooling liquid 80 C
1,48 – 1,58 kOhm