Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
- 5. Cooling and heating
   5.2. General information
   5.3. Antifreeze
   5.4. Cooling system hoses
   + 5.5. Check and replacement of the thermostat
   - 5.6. Check and replacement of the fan of a radiator and relay
      5.6.2. Check of the relay
      5.6.3. Replacement
   + 5.7. The radiator fan (the V6 models from 1992 to 1994)
   + 5.8. Radiator
   5.9. Broad tank
   + 5.10. Water pump
   + 5.11. Sensor of temperature of cooling liquid
   5.12. Heater fan
   5.13. Heater fan resistor
   5.14. Heater radiator
   + 5.15. Control panel of a heater
   5.16. Air conditioning system
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment




5.6.3. Replacement

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.

Preventions

In the presence in the code radio receiver against theft, before an accumulator detachment, check that you have connection codes.

On models since 1993 the system of the airbag of safety is disconnected if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for maintenance of system.


2. Disconnect the electric socket from the radiator fan engine.
3. On models about a cruise control remove a casing of the executive mechanism a cruise control for more convenient removal of the fan of a radiator. 4. Unscrew bolts of fastening of a casing of the fan to a radiator and remove assembly of the fan from the car.
5. Holding fan blades from a provorachivaniye, unscrew a nut of fastening and remove the fan from the engine. 6. Unscrew bolts of fastening of the engine of the fan of a radiator to a fan casing.
7. Installation is made in the sequence, the return to removal.