Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
- 4. Capital repairs of engines
   4.2. General information
   4.3. Check of a compression
   4.4. Recommendations about removal of the engine
   + 4.5. Removal and installation of the engine
   4.6. Sequence of dismantling of the engine
   4.7. Dismantling of a head of the block of cylinders
   + 4.8. Cleaning and survey of a head of the block of cylinders
   4.9. Assembly of a head of the block of cylinders
   4.10. Removal of pistons with rods
   4.11. Removal of a bent shaft
   + 4.12. Block of cylinders of the engine
   4.13. Pistons and rods
   4.14. Bent shaft
   + 4.15. Survey and choice of radical and conrod bearings
   4.16. Control of a side play of assembly of the balance weight (engine 5S-FE)
   4.17. Engine balance of assembly at capital repairs
   4.18. Installation of piston rings
   + 4.19. Installation of a bent shaft and check of working gaps of bearings
   4.20. Installation of a back sealing ring of a bent shaft
   4.21. Installation of pistons and rods, check of working gaps of bearings
   4.22. Installation of assembly of the balance weight (engine 5S-FE)
   4.23. Start of the engine after capital repairs
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment




4.7. Dismantling of a head of the block of cylinders

PERFORMANCE ORDER
1. When dismantling a head of the block of cylinders note details for their installation on the places.
2. Before removal of valves prepare the place for storage of the corresponding details. 3. Using the device for compression of a spring of the valve, squeeze each spring and remove crackers from a valve end face. Remove the device for compression of a spring and take a plate springs and a spring. Flat-nose pliers, being careful, take a maslootrazhatelny cap from a valve rod.
4. When the spring of the valve is removed, and the cup of a spring does not remove ся from crackers, it is necessary to strike with the hammer through wooden whetstone a spring cup that will lead to release of crackers.
5. Take the valve via the combustion chamber. Each valve you store in a separate plastic bag together with a plate springs, a spring, a nest of a spring and crackers for their further installation on the places.
6. Similarly remove the others of the valve from a head of the block of cylinders.