Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
- 3. Six-cylinder V6 engines
   3.2. General information
   3.3. The repair which is not demanding removal of the engine
   - 3.4. Top Dead Point (TDP) of the piston of the first cylinder
      3.4.1. Engine 3VZ-FE
      3.4.2. Engine 1MZ-FE
   + 3.5. Cover of a head of the block of cylinders
   + 3.6. Inlet collector
   3.7. Final collector
   + 3.8. Gear belt and pulleys
   3.9. Replacement of a forward sealing ring of a bent shaft
   3.10. Replacement of sealing rings of camshafts
   + 3.11. Camshafts and pushers
   + 3.12. Head of the block of cylinders
   + 3.13. Oil pallet
   + 3.14. Oil pump
   3.15. Drive flywheel / plate
   3.16. Replacement of a back sealing ring of a bent shaft
   3.17. Suspension bracket of the power unit
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment




3.4.1. Engine 3VZ-FE

GENERAL INFORMATION

Arrangement of high-voltage wires on an ignition distributor cover

PERFORMANCE ORDER
1. Note position of the plug of the first cylinder on a distributor cover. If the tag is absent, determine it by the high-voltage wire going from a candle of the first cylinder.
2. Using chalk or a felt-tip pen, put the tag located under contact of the first cylinder on the distributor case.
3. Uncover the distributor and move it aside.
4. Turn a bent shaft of the engine until the tag on a pulley of a bent shaft is combined with figure 0 on a plate of the installation of the mechanism of gas distribution located on the forward party of the engine.
5. Check the provision of a rotor of the distributor which has to be directed to the tag applied on the distributor case. If the rotor of the distributor is sent to the opposite side, then the piston of the first cylinder is in the top dead point in an exhaust step.
6. For installation of the piston of the first cylinder in VMT in a step of compression turn a bent shaft on 360 ° clockwise. At the same time the rotor of the distributor has to be combined with a tag.