Toyota Camry

1992-1997 of release

Repair and operation of the car

Toyota Camry
+ General data
+ 1. Maintenance
- 2. Engine
   2.2. Operations on repair of the engine on the car
   2.3. Top dead point of the first cylinder
   + 2.4. Cover of a head of the block of cylinders
   + 2.5. Inlet collector
   + 2.6. Final collector
   + 2.7. Gear belt and pulleys
   2.8. Replacement of a forward sealing ring of a bent shaft
   2.9. Replacement of a sealing ring of the camshaft
   + 2.10. Camshaft and pushers
   + 2.11. Head of the block of cylinders
   + 2.12. Oil pallet
   + 2.13. Oil pump
   + 2.14. Drive flywheel / plate
   2.15. Replacement of a back sealing ring of a bent shaft
   - 2.16. Suspension bracket of the power unit
      2.16.2. Replacement
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment

2.16.2. Replacement

GENERAL INFORMATION

Preventions

In the presence in the code radio receiver against theft, before an accumulator detachment, check that you have connection codes.

On models since 1993 the system of the airbag of safety is disconnected if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for maintenance of system.

PERFORMANCE ORDER

1. Remove a weight wire from the accumulator. Using the load-lifting mechanism, support the engine.

2. For removal of the right suspension bracket of the power unit unscrew a nut and take a coupling bolt from a suspension bracket.

3. Unscrew nuts of fastening of a suspension bracket of the power unit to an arm and remove a suspension bracket.

4. For removal of a back suspension bracket of the power unit take rubber traffic jams from a body for access to three nuts of fastening of a suspension bracket.

5. For removal of a forward suspension bracket of the power unit unscrew the nut fixing an elastic element to a basic arm of the engine. Then unscrew three nuts of fastening of a suspension bracket to a body of the car and remove a suspension bracket.

6. Installation is made in the sequence, the return to removal.