Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
- 1. Maintenance
   1.2. Frequency of service
   - 1.3. Maintenance
      + 1.3.1. Each 400 km or weekly
      + 1.3.2. Each 5 000 km or 3 months
      - 1.3.3. Each 10 000 km or 6 months
         1.3.3.1.1. Type A
         1.3.3.1.2. Type B
         1.3.3.2. Check of a free wheeling and height of installation of a pedal of coupling
         + 1.3.3.3. Check and service of the accumulator
         - 1.3.3.4. Check and replacement of a driving belt
            1.3.3.4.2. Adjustment
            1.3.3.4.3. Replacement
         + 1.3.3.5. Check of tightness of hoses and effluence of liquids
         1.3.3.6. Check of the cooling system
         1.3.3.7. Change of provision of installation of tires
      + 1.3.4. Each 25 000 km or 12 months
      + 1.3.5. Each 50 000 km or 24 months
      + 1.3.6. Each 100 000 km or 48 months
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment




1.3.3.4. Check and replacement of a driving belt

1.3.3.4.1. Check

GENERAL INFORMATION

Driving belts are located on the right side of the engine.

Depending on a complete set of the car and the engine installed in it, several driving belts are used. One belt is used for torque transmission from a bent shaft to the generator and the compressor of the conditioner. If the car is equipped by the amplifier of steering, for the drive of the pump of the amplifier of steering to an ispolz the separate belt etsyatsya.

PERFORMANCE ORDER
1. Open the cover closing belts and check a condition of belts for existence of cracks, stratifications and oiling. If necessary replace a belt.
2. For check of a tension of a driving belt use the special Nippondenso or Burroughs tools. A tension for the new and being in the use belt differ. Being in the use is considered the belt which worked on the engine more than 5 minutes.
3. In the absence of special tools the tension of a driving belt needs to be adjusted so that when pressing by a hand thumb on a long branch of a belt the deflection made about 5 mm if the distance between the central pulleys makes about 250 mm, or 10 mm if the distance between the central pulleys makes about 350 mm (1 – a ruler, 2 – a ruler, 3 – a belt deflection).