Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
- 11. Coupling and power shafts
   11.2. General information
   + 11.3. Check and replacement of a clutch plate
   + 11.4. Release bearing
   + 11.5. Main cylinder of coupling
   + 11.6. Working cylinder of coupling
   11.7. Removal of air from hydraulic system of coupling
   11.8. Starting switch of coupling
   + 11.9. Hinge of Equal Angular Speeds (HEAS)
   - 11:10. Replacement of protective covers and repair of hinges of equal angular speeds
      + 11.10.1. Models with the engine 5S-FE
      - 11.10.2. Models with the engine 3VZ-FE or 1MZ-FE
         11.10.2.2. Check
         11.10.2.3. Assembly
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment




11.10.2.3. Assembly

GENERAL INFORMATION

Measurement of length of a power shaft
 

PERFORMANCE ORDER
1. Establish new covers of hinges of equal angular speeds on a power shaft.
2. Apply a thin film of sealant on the interfaced hinge casing surface.
3. Install a casing on the internal hinge. At the same time combine openings under fastening bolts in a casing and the internal hinge. Temporarily establish bolts in openings.
4. Using the plastic hammer and striking blows in the sequence shown in the drawing, get a casing on the internal hinge.
5. Install the internal hinge on a power shaft according to earlier made tags.
6. Fix it by a lock ring.
7. Fill the hinge with lubricant.
8. Screw a driving flange or an intermediate shaft on the internal hinge.
9. Install a protective cover on the hinge of equal angular speeds.
10. Establish the required length of a power shaft, then, using the screw-driver, remove air from under a protective cover and fix protective covers by collars (see rice. Measurement of length of a power shaft).