Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
- 6. Fuel system
   6.2. General information
   6.3. Removal of pressure in fuel system
   + 6.4. Check of the fuel pump
   6.5. Fuel pump
   + 6.6. Fuel level sensor
   6.7. Fuel tank
   6.8. Air filter
   + 6.9. Accelerator cable
   6.10. Electronic system of injection of EFL fuel
   + 6.11. Fuel system
   6.12. Check of system of injection of fuel
   + 6.13. Check and replacement of elements of system of injection of EFI fuel
   6.14. Fuel highway and fuel nozzles
   + 6.15. Valve of the mode of idling of the air conditioning system
   6.16. Air inlet camera (only V6 engines)
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment




6.16. Air inlet camera (only V6 engines)

6.16.1. Removal

GENERAL INFORMATION

V6 engine air inlet camera

1 – fuel-supply line;
2 – left fuel highway;
3 – laying;
4 – arm;
5 – air inlet camera arm;
6 – casing;
7 – adjusting valve;
8 – air inlet camera;
9 – air duct;
10 – laying;

11 – right fuel highway;
12 – sealing ring of round section;
13 – sealing ring;
14 – fuel nozzle;
15 – sealing ring;
16 – sealing ring of round section;
17 – laying;
18 – laying;
19 – laying


PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
Preventions

In the presence in the code radio receiver against theft, before a detachment of the accumulator check that you have connection codes.

On models since 1993 the system of the airbag of safety is disconnected if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for maintenance of system.


2. Disconnect the electric socket from the IAC valve, the sensor of provision of a butterfly valve (TPS), the MAF sensor and the electromagnetic EGR/EVAP valve.
3. Disconnect a cable of an accelerator and draft of control of the transmission from the throttle case.
4. Disconnect an accelerator cable from an inlet collector.
5. Mark, then disconnect vacuum hoses from the camera of an air inlet, the EGR valve, the ACIS valve and the regulator of pressure of fuel (see rice. V6 engine air inlet camera).
6. Unscrew a bolt of fastening of an arm of the camera of an air inlet.
7. Disconnect hoses of supply of cooling liquid to the throttle case.
8. Unscrew bolts of fastening of the camera of an air inlet.
9. Remove the air inlet camera together with the throttle case from an inlet collector.
10. Installation is made in the sequence, the return to removal. At the same time it is necessary to use new laying and sealing rings.