Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
- 6. Fuel system
   6.2. General information
   6.3. Removal of pressure in fuel system
   + 6.4. Check of the fuel pump
   6.5. Fuel pump
   + 6.6. Fuel level sensor
   6.7. Fuel tank
   6.8. Air filter
   + 6.9. Accelerator cable
   6.10. Electronic system of injection of EFL fuel
   + 6.11. Fuel system
   6.12. Check of system of injection of fuel
   - 6.13. Check and replacement of elements of system of injection of EFI fuel
      6.13.1.2. Replacement
      + 6.13.2. Sensor of provision of a butterfly valve (TPS)
      6.13.3. Fuel pressure regulator
      + 6.13.4. Nozzle of cold start of the engine (engine 3VZ-FE V6)
      + 6.13.5. Timer of a nozzle of cold start of the engine of the V6 model 3VZ-FE
      + 6.13.6. Control air valve (IAC)
   6.14. Fuel highway and fuel nozzles
   + 6.15. Valve of the mode of idling of the air conditioning system
   6.16. Air inlet camera (only V6 engines)
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment




6.13.3. Fuel pressure regulator

6.13.3.1. Replacement

GENERAL INFORMATION

Arrangement of a sealing ring of round section at installation of the regulator of pressure upon the fuel highway

PERFORMANCE ORDER
1. Take off pressure in the fuel highway.
2. Remove a weight wire from the accumulator.

Preventions

In the presence in the code radio receiver against theft, before a detachment of the accumulator check that you have connection codes.

On models since 1993 the system of the airbag of safety is disconnected if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for maintenance of system.


3. Disconnect a vacuum hose from the fuel pressure regulator.
4. Weaken a collar and remove a returnable fuel hose from pressure regulator.
5. Unscrew bolts of fastening of the regulator of pressure and remove pressure regulator from the fuel highway.
6. Using a sealing ring of round section, install the regulator of pressure upon the fuel highway (see rice. An arrangement of a sealing ring of round section at installation of the regulator of pressure upon the fuel highway).
7. Further installation is made in the sequence, the return to removal.