Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
- 6. Fuel system
   6.2. General information
   6.3. Removal of pressure in fuel system
   + 6.4. Check of the fuel pump
   6.5. Fuel pump
   + 6.6. Fuel level sensor
   6.7. Fuel tank
   6.8. Air filter
   + 6.9. Accelerator cable
   6.10. Electronic system of injection of EFL fuel
   + 6.11. Fuel system
   6.12. Check of system of injection of fuel
   - 6.13. Check and replacement of elements of system of injection of EFI fuel
      6.13.1.2. Replacement
      - 6.13.2. Sensor of provision of a butterfly valve (TPS)
         6.13.2.2. Replacement
      6.13.3. Fuel pressure regulator
      + 6.13.4. Nozzle of cold start of the engine (engine 3VZ-FE V6)
      + 6.13.5. Timer of a nozzle of cold start of the engine of the V6 model 3VZ-FE
      + 6.13.6. Control air valve (IAC)
   6.14. Fuel highway and fuel nozzles
   + 6.15. Valve of the mode of idling of the air conditioning system
   6.16. Air inlet camera (only V6 engines)
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment




6.13.2. Sensor of provision of a butterfly valve (TPS)

6.13.2.1. Check

GENERAL INFORMATION

Check of resistance between the corresponding contacts of the sensor of provision of a butterfly valve on four-cylinder engines

Check of resistance between the corresponding contacts of the socket of the sensor of provision of a butterfly valve on six-cylinder engines

PERFORMANCE ORDER
1. Disconnect the electric socket from the sensor of provision of a butterfly valve (TPS) and give vacuum to a throttle positioner.
2. Install the probe 0,7 mm thick between the screw of adjustment of turns of idling and an emphasis.
3. Using an ohmmeter, measure resistance between the corresponding couples of contacts of the electric socket (see rice. Check of resistance between the corresponding contacts of the sensor of provision of a butterfly valve on four-cylinder engines and rice. Check of resistance between the corresponding contacts of the socket of the sensor of provision of a butterfly valve on six-cylinder engines).
If the measured resistance differs from the required values, install the probe 0,7 mm thick between the screw of adjustment of turns of idling and an emphasis and connect an ohmmeter to contacts of IGL and E2. Weaken screws of fastening of the sensor of provision of a butterfly valve and slowly rotate the sensor clockwise until the ohmmeter shows infinity.
4. Tighten screws of fastening of the sensor of provision of a butterfly valve, install the probe and repeatedly measure resistance between the corresponding contacts.