Toyota Camry

1992-1997 of release

Repair and operation of the car

Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
- 5. Cooling and heating
   5.2. General information
   5.3. Antifreeze
   5.4. Cooling system hoses
   - 5.5. Check and replacement of the thermostat
      5.5.2. Replacement
   + 5.6. Check and replacement of the fan of a radiator and relay
   + 5.7. The radiator fan (the V6 models from 1992 to 1994)
   + 5.8. Radiator
   5.9. Broad tank
   + 5.10. Water pump
   + 5.11. Sensor of temperature of cooling liquid
   5.12. Heater fan
   5.13. Heater fan resistor
   5.14. Heater radiator
   + 5.15. Control panel of a heater
   5.16. Air conditioning system
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment

5.5.2. Replacement


Arrangement of the thermostat and water pump on engines 3VZ-FE V6
1 – water supply branch pipe;
2 – sealing ring of round section;
3 – thermostat cover;
4 – sealing ring;
5 – thermostat;
6 – water pump

1. Remove a weight wire from the accumulator.


In the presence in the code radio receiver against theft, before a detachment of the accumulator check that you have connection codes.

On models since 1993 the system of the airbag of safety is disconnected if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for maintenance of system.

2. Merge cooling liquid from a radiator.
3. On four-cylinder engines remove a water supply branch pipe in the engine from a radiator which is located on the case of the water pump. For access to bolts of fastening of a branch pipe remove an oil filter.
4. On models with V6 engines unscrew a bolt of fastening of a branch pipe of water supply and remove a branch pipe together with a sealing ring (see rice. An arrangement of the thermostat and water pump on engines 3VZ-FE V6).
5. Disconnect electric sockets from a casing of the thermostat and remove a thermostat casing from the engine. For improvement of access to a thermostat casing on the engine 1MZ-FE remove a casing of the air filter and hoses.
6. Remove the thermostat, noting situation in which it was installed.
7. Install new laying on the thermostat.
8. Install the thermostat in a casing.
9. Install a thermostat casing on the block of cylinders and fix by bolts.
10. Fill in cooling liquid in the engine cooling system.