Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
- 4. Capital repairs of engines
   4.2. General information
   4.3. Check of a compression
   4.4. Recommendations about removal of the engine
   - 4.5. Removal and installation of the engine
      4.5.1. Removal
      4.5.2. Installation
   4.6. Sequence of dismantling of the engine
   4.7. Dismantling of a head of the block of cylinders
   + 4.8. Cleaning and survey of a head of the block of cylinders
   4.9. Assembly of a head of the block of cylinders
   4.10. Removal of pistons with rods
   4.11. Removal of a bent shaft
   + 4.12. Block of cylinders of the engine
   4.13. Pistons and rods
   4.14. Bent shaft
   + 4.15. Survey and choice of radical and conrod bearings
   4.16. Control of a side play of assembly of the balance weight (engine 5S-FE)
   4.17. Engine balance of assembly at capital repairs
   4.18. Installation of piston rings
   + 4.19. Installation of a bent shaft and check of working gaps of bearings
   4.20. Installation of a back sealing ring of a bent shaft
   4.21. Installation of pistons and rods, check of working gaps of bearings
   4.22. Installation of assembly of the balance weight (engine 5S-FE)
   4.23. Start of the engine after capital repairs
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment




4.5.2. Installation

GENERAL INFORMATION

Prevention

Do not use bolts for alignment of the transmission concerning the engine. It can lead to splitting or damage of large knots of the engine.


PERFORMANCE ORDER

1. Check a condition of support of engine mounts and the transmission. If they are worn-out or damaged, replace them.

2. On models with the mechanical transmission check a condition of coupling. On models with the automatic transmission check a condition of a sealing ring and the plug.

3. On models with the mechanical transmission grease with a small amount of high-temperature lubricant the bearing in an end face of a bent shaft. On models with the automatic transmission grease with high-temperature lubricant a nasal part of the converter.
4. Being careful, install the transmission on the engine.
5. Fix by bolts the transmission to the engine, having tightened them the required moment.
6. Using the load-lifting mechanism, lower the engine together with the transmission in a motor compartment. At installation of the power unit, if necessary, incline and turn it so that it was established into place, without having done harm.
7. Establish bolts of fastening of a suspension bracket of the power unit and tighten them the required moment.
8. Establish earlier removed details and restore everything connect a niya in the sequence, the return to removal.
9. Fill in cooling liquid, engine oil in the engine and, if necessary, add oil to a tank of the amplifier of steering.
10. Start the engine and check its work. Switch off the engine and check the level of all liquids.