Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
- 4. Capital repairs of engines
   4.2. General information
   4.3. Check of a compression
   4.4. Recommendations about removal of the engine
   + 4.5. Removal and installation of the engine
   4.6. Sequence of dismantling of the engine
   4.7. Dismantling of a head of the block of cylinders
   + 4.8. Cleaning and survey of a head of the block of cylinders
   4.9. Assembly of a head of the block of cylinders
   4.10. Removal of pistons with rods
   4.11. Removal of a bent shaft
   - 4.12. Block of cylinders of the engine
      4.12.2. Check
      4.12.3. Honingovaniye of cylinders
   4.13. Pistons and rods
   4.14. Bent shaft
   + 4.15. Survey and choice of radical and conrod bearings
   4.16. Control of a side play of assembly of the balance weight (engine 5S-FE)
   4.17. Engine balance of assembly at capital repairs
   4.18. Installation of piston rings
   + 4.19. Installation of a bent shaft and check of working gaps of bearings
   4.20. Installation of a back sealing ring of a bent shaft
   4.21. Installation of pistons and rods, check of working gaps of bearings
   4.22. Installation of assembly of the balance weight (engine 5S-FE)
   4.23. Start of the engine after capital repairs
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment




4.12.3. Honingovaniye of cylinders

GENERAL INFORMATION

Honingovaniye of walls of cylinders creates optimum conditions for work of piston rings. The greatest distribution was gained by the honingovalny tool with the sprung whetstones. The honingovalny tool in the form of a round wire brush is also widely used. Besides, carrying out a honingovaniye will require a kerosene quantity, rags and an electric sverlilka.

PERFORMANCE ORDER
1. Establish to the place of a cover of radical bearings and tighten bolts of fastening them the required moment.
2. Fix the honingovalny tool on an electric sverlilka and insert it into the cylinder.
3. Grease with a thin layer of kerosene of a wall of the cylinder, include an electric sverlilka and move the honingovalny tool up and down to that time while on walls the correct crossed drawing is not formed. Ideally lines have to be crossed at an angle 60 °. You watch that in the course of a honingovaniye of a wall were moistened with a thin layer of kerosene.
4. Do not take the honingovalny tool from the block of cylinders at the included electric sverlilka. Moreover, make several courses of the honingovalny tool at the switched-off sverlilka and only after that take it from the block of cylinders.
5. Similarly to an otkhoninguyta other cylinders.
6. Carefully wash out the block of cylinders from the remains of the abrasive tool.
7. Dry up the block of cylinders and grease surfaces with a thin butter layer.