Repair and operation of the Toyota Camry car - 3.11.3.1. The cam-shaft operating inlet valves of the right head//Toyota Camry of 1992-1997 /

Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
- 3. Six-cylinder V6 engines
   3.2. General information
   3.3. The repair which is not demanding removal of the engine
   + 3.4. Top Dead Point (TDP) of the piston of the first cylinder
   + 3.5. Cover of a head of the block of cylinders
   + 3.6. Inlet collector
   3.7. Final collector
   + 3.8. Gear belt and pulleys
   3.9. Replacement of a forward sealing ring of a bent shaft
   3.10. Replacement of sealing rings of camshafts
   - 3.11. Camshafts and pushers
      3.11.2. Check
      - 3.11.3. Installation
         3.11.3.1. The cam-shaft operating inlet valves of the right head
         3.11.3.2. The cam-shaft operating final valves of the right head
   + 3.12. Head of the block of cylinders
   + 3.13. Oil pallet
   + 3.14. Oil pump
   3.15. Drive flywheel / plate
   3.16. Replacement of a back sealing ring of a bent shaft
   3.17. Suspension bracket of the power unit
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



3.11.3.1. The cam-shaft operating inlet valves of the right head

PERFORMANCE ORDER
1. Oil pure engine cams, necks of bearings and persistent surfaces of gear wheels of the camshaft.
2. Install the camshaft in a head of the block of cylinders so that tags on a gear wheel (two points) were directed to the camshaft operating inlet valves.
3. Apply a thin film of sealant on an external part of the interfaced surfaces of a forward cover of the camshaft.
4. Establish a cover of bearings of the camshaft so that shooters on covers were directed to a forward part of the engine.
5. Tighten bolts of fastening of covers of bearings of the camshaft, turning them for one pass on 1/3 turns in the order shown in the drawing.
6. Establish a new sealing ring of the camshaft.