Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
- 3. Six-cylinder V6 engines
   3.2. General information
   3.3. The repair which is not demanding removal of the engine
   + 3.4. Top Dead Point (TDP) of the piston of the first cylinder
   + 3.5. Cover of a head of the block of cylinders
   + 3.6. Inlet collector
   3.7. Final collector
   + 3.8. Gear belt and pulleys
   3.9. Replacement of a forward sealing ring of a bent shaft
   3.10. Replacement of sealing rings of camshafts
   - 3.11. Camshafts and pushers
      3.11.2. Check
      + 3.11.3. Installation
   + 3.12. Head of the block of cylinders
   + 3.13. Oil pallet
   + 3.14. Oil pump
   3.15. Drive flywheel / plate
   3.16. Replacement of a back sealing ring of a bent shaft
   3.17. Suspension bracket of the power unit
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment




3.11. Camshafts and pushers

3.11.1. Removal

PERFORMANCE ORDER
1. Uncover a head of the block of cylinders.
2. On the engine 3VZ-FE remove the ignition distributor.
3. On both heads, first of all, act distribute the telny shaft operating final valves. Before removal of camshafts it is necessary to combine adjusting tags on gear wheels of camshafts.
4. Using an additional bolt, fix the removable sprung gear wheel to a motionless gear wheel the distributor a leg of the shaft operating final valves.
5. Working in the sequence, return shown in the drawing, weaken bolts of fastening of covers of bearings of the camshaft on a half of a turn for each pass before full unscrewing of bolts.
6. Remove the camshaft operating final valves.
7. Working in the sequence, return shown in the drawing, weaken bolts of fastening of covers of bearings of the camshaft operating inlet the valve ми on a half of a turn for each pass to full of an otvincha of a vaniye of bolts.
8. Uncover bearings of the camshaft and a sealing ring and remove the camshaft from a head of the block of cylinders.
9. Similarly remove and install camshafts on the left head of the block of cylinders.
10. If it is necessary, remove valve pushers together with adjusting laying from a head of the block of cylinders and you store them so that they could be established on former places.

11. Install in a vice with soft sponges the camshaft operating final valves.

12. Establish a special key with two pins on the end in two technological openings of the sprung gear wheel, turn a gear wheel clockwise and unscrew the additional bolt fixing the sprung gear wheel to a camshaft gear wheel and smoothly release it is sprung a ny gear wheel.
13. Remove a lock ring of fastening of the sprung gear wheel.
14. Remove a spring persistent ring, a gear wheel and a spring ring from the camshaft operating final valves.