Repair and operation of the Toyota Camry car - 2.7.3. Installation//Toyota Camry of 1992-1997 /

Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
- 2. Engine
   2.2. Operations on repair of the engine on the car
   2.3. Top dead point of the first cylinder
   + 2.4. Cover of a head of the block of cylinders
   + 2.5. Inlet collector
   + 2.6. Final collector
   - 2.7. Gear belt and pulleys
      2.7.2. Survey
      2.7.3. Installation
   2.8. Replacement of a forward sealing ring of a bent shaft
   2.9. Replacement of a sealing ring of the camshaft
   + 2.10. Camshaft and pushers
   + 2.11. Head of the block of cylinders
   + 2.12. Oil pallet
   + 2.13. Oil pump
   + 2.14. Drive flywheel / plate
   2.15. Replacement of a back sealing ring of a bent shaft
   + 2.16. Suspension bracket of the power unit
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment
где купить обложки на паспорт в челябинске
На нашем фан-сайте о ФК Челси вы всегда сможете быть в курсе всех новостей



2.7.3. Installation

PERFORMANCE ORDER
1. If single pulleys were removed, establish them and a spring of stretching. Stretching a spring, move the top single pulley to the left as far as possible and temporarily fix by a bolt.
2. Check tags of combination of a pulley of a distributive and bent shaft.
3. Consistently establish a gear belt on pulleys of a bent shaft, the oil pump, water pump and single pulleys. If the belt is established repeatedly, combine those earlier made tags on a gear belt and pulleys.
4. Establish a guide of a gear belt to a pulley of a bent shaft. At the same time the convex party of a guide has to be directed to a pulley of a bent shaft.
5. Establish the lower casing of a gear belt and a pulley of a bent shaft.
6. Establish a gear belt on a camshaft pulley, at the same time constantly you hold tense a forward branch of a gear belt.
7. Weaken a bolt of fastening of the top single pulley. At the same time the spring will turn a single pulley and will make a tension of a gear belt.
8. If a spring of a tension of a gear belt silver, slowly turn a bent shaft clockwise on two whole revolutions and tighten a bolt of fastening of the top single pulley. If a spring of a tension of a gear belt green, turn a bent shaft on 1 7/8 turns and tighten a bolt of fastening of the top single pulley of a gear belt.


9. Repeatedly check combination of adjusting tags.

10. Further installation is made in the sequence, the return to removal.