Toyota Camry

1992-1997 of release

Repair and operation of the car

Toyota Camry
+ General data
+ 1. Maintenance
- 2. Engine
   2.2. Operations on repair of the engine on the car
   2.3. Top dead point of the first cylinder
   - 2.4. Cover of a head of the block of cylinders
      2.4.1. Removal
      2.4.2. Installation
   + 2.5. Inlet collector
   + 2.6. Final collector
   + 2.7. Gear belt and pulleys
   2.8. Replacement of a forward sealing ring of a bent shaft
   2.9. Replacement of a sealing ring of the camshaft
   + 2.10. Camshaft and pushers
   + 2.11. Head of the block of cylinders
   + 2.12. Oil pallet
   + 2.13. Oil pump
   + 2.14. Drive flywheel / plate
   2.15. Replacement of a back sealing ring of a bent shaft
   + 2.16. Suspension bracket of the power unit
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment

2.4.1. Removal



In the presence in the code radio receiver against theft, before an accumulator detachment, check that you have connection codes.

On models since 1993 the system of the airbag of safety is disconnected if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for maintenance of system.

1. Remove a weight wire from the accumulator.
2. Disconnect a hose of ventilation of a case of the engine from a cover of a head of the block of cylinders.
3. Remove high-voltage wires from spark plugs.
4. Unscrew two bolts and remove the top casing of a gear belt.
5. Unscrew the nuts fixing a head cover to pipes of spark plugs.
6. Being careful, uncover a head of the block of cylinders. If the cover was pasted to a head of the block of cylinders, do not enter the lever or the screw-driver between a cover and a head of the block of cylinders. The wooden hammer easy blows bring down a cover from a head of the block of cylinders.