Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
- 2. Engine
   2.2. Operations on repair of the engine on the car
   2.3. Top dead point of the first cylinder
   + 2.4. Cover of a head of the block of cylinders
   + 2.5. Inlet collector
   + 2.6. Final collector
   + 2.7. Gear belt and pulleys
   2.8. Replacement of a forward sealing ring of a bent shaft
   2.9. Replacement of a sealing ring of the camshaft
   + 2.10. Camshaft and pushers
   + 2.11. Head of the block of cylinders
   + 2.12. Oil pallet
   + 2.13. Oil pump
   + 2.14. Drive flywheel / plate
   2.15. Replacement of a back sealing ring of a bent shaft
   + 2.16. Suspension bracket of the power unit
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment




2.15. Replacement of a back sealing ring of a bent shaft

PERFORMANCE ORDER
1. Remove the transmission and a flywheel.

2. The easiest way of extraction old uplotnitelno го rings is in that the screw-driver to hook on a sealing ring and to take it from a nest.
3. Also sealing ring can be taken from a nest if to drill two small openings located in the opposite ends of a sealing ring in a ring. Screw in two self-cutting screws in the drilled openings of a sealing ring and, using flat-nose pliers, extend a sealing ring for heads of screws.
4. The most reliable method of replacement of a back sealing ring of a bent shaft is that it is necessary to remove the oil pallet and a back cover of a bent shaft together with a sealing ring.

5. Establish a back cover of a bent shaft together with condense with a telny ring on wooden whetstones and, using the hammer and the screw-driver, beat out an old sealing ring from a cover.
6. Using wooden whetstone and the hammer, establish a new sealing ring of a bent shaft in a back cover.
7. Clear the interfaced surfaces of the block of cylinders and a back cover of a bent shaft and install new laying on the block of cylinders.
8. Being careful, establish a back cover with condense with a telny ring on the engine.
9. Fix a back cover of a bent shaft by bolts, having tightened them the required moment, at the same time the lower edge of a back cover has to be flush with bottom edge of the block of cylinders of the engine.

10. Further installation is made in the sequence, the return to removal.