Toyota Camry

1992-1997 of release

Repair and operation of the car

Toyota Camry
+ General data
+ 1. Maintenance
- 2. Engine
   2.2. Operations on repair of the engine on the car
   2.3. Top dead point of the first cylinder
   + 2.4. Cover of a head of the block of cylinders
   + 2.5. Inlet collector
   + 2.6. Final collector
   + 2.7. Gear belt and pulleys
   2.8. Replacement of a forward sealing ring of a bent shaft
   2.9. Replacement of a sealing ring of the camshaft
   - 2.10. Camshaft and pushers
      + 2.10.1.1. The camshaft operating final valves
      2.10.2. Check
      - 2.10.3. Installation
         2.10.3.2. The camshaft operating final valves
   + 2.11. Head of the block of cylinders
   + 2.12. Oil pallet
   + 2.13. Oil pump
   + 2.14. Drive flywheel / plate
   2.15. Replacement of a back sealing ring of a bent shaft
   + 2.16. Suspension bracket of the power unit
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment

2.10.3.2. The camshaft operating final valves

PERFORMANCE ORDER

1. Oil pushers pure engine and establish them in a head of the block of cylinders together with adjusting laying.
2. Oil pure engine cams and necks of a podshipna of k of the camshaft.
	3. Turn the camshaft operating vpuskna ми valves in such situation that the adjusting pin was established on 10 ° from the vertical line to the left.
	4. Install the camshaft operating vypuskna ми valves in a head of the block of cylinders so that tags on gear wheels of shaft were combined.
	5. Establish covers of bearings of the camshaft according to identification tags, at the same time shooters on covers have to be directed to a forward part of the engine.
	6. Gradually and consistently in the order shown in the drawing screw up bolts of fastening of covers of bearings of the camshaft.
7. Install a pulley of a gear belt on the camshaft operating inlet valves and tighten it the required moment, at the same time hold the camshaft from a provorachivaniye the second wrench.
8. Establish a gear belt.
9. Further installation is made in the sequence, the return to removal.