Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
- 15. Electric equipment
   15.2. General information
   15.3. Electric chains
   + 15.4. Detection of not closed chain
   15.5. Safety locks
   15.6. Relay
   + 15.7. Multipurpose switches of a steering column
   - 15.8. Ignition lock
      15.8.2. Replacement
   15.9. Switch of a heater of back glass
   15:10. Check of a heater of back glass
   15:11. Radio receiver
   15:12. Loudspeakers
   15:13. Antenna
   15:14. Replacement of bulbs of headlights
   15:15. Adjustment of light of headlights
   15:16. Headlight
   + 15:17. Replacement of bulbs of an incandescence
   + 15:18. Screen wiper engine
   15:19. Combination of devices
   15:20. Sound signal
   15:21. System cruise control
   15:22. Window regulators with the electric drive
   15:23. System of the central blocking of locks
   15:24. Rear-view mirrors with the electric drive
   15:25. Safety airbag
   + 15:26. Schemes of electric equipment




15.8.2. Replacement

GENERAL INFORMATION

Ignition lock details
 
1 – contact group of the lock of ignition;
2 – blocking solenoid key;
3 – ignition lock cylinder;
4 – ignition lock illumination element;
5 – ignition lock case;
6 – bracket of fastening of the lock of ignition;
7 – top part of a steering column

PERFORMANCE ORDER
1. Remove the branch pipe of system of heating and ventilation located under a steering column.
2. Unscrew the screws fixing a back part of the lock of ignition and remove the ignition lock (see rice. Ignition lock details).
3. Remove a decorative ring of a frame of the cylinder of the lock of ignition.
4. Install the ignition key in the ignition lock in the provision of ASS and through an opening in the case of the lock of ignition press a clamp and for a key take the ignition lock cylinder.
5. Installation is made in the sequence, the return to removal.