Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
- 15. Electric equipment
   15.2. General information
   15.3. Electric chains
   + 15.4. Detection of not closed chain
   15.5. Safety locks
   15.6. Relay
   - 15.7. Multipurpose switches of a steering column
      15.7.2. Replacement
   + 15.8. Ignition lock
   15.9. Switch of a heater of back glass
   15:10. Check of a heater of back glass
   15:11. Radio receiver
   15:12. Loudspeakers
   15:13. Antenna
   15:14. Replacement of bulbs of headlights
   15:15. Adjustment of light of headlights
   15:16. Headlight
   + 15:17. Replacement of bulbs of an incandescence
   + 15:18. Screen wiper engine
   15:19. Combination of devices
   15:20. Sound signal
   15:21. System cruise control
   15:22. Window regulators with the electric drive
   15:23. System of the central blocking of locks
   15:24. Rear-view mirrors with the electric drive
   15:25. Safety airbag
   + 15:26. Schemes of electric equipment




15.7.2. Replacement

GENERAL INFORMATION

Multipurpose switches of a steering column
1 – casing of a plait of wires;
2 – fastening bracket;
3 – ball;
4 – spring;
5 – switch handle;
6 – lighting switch;
7 – basis of switches;
8 – screen wiper switch;
9 – knot of the spiral drive

PERFORMANCE ORDER
1. Remove a steering wheel.
2. Unscrew screws of fastening of the multipurpose switch.
3. Release clamps and remove the switch together with a plait of wires from a steering column.
4. Unscrew screws of fastening and remove the tel demanded a rekey from the basis of switches (see rice. Multipurpose switches of a steering column).
5. Take contacts of wires of the replaced switch and socket. From a forward part of the socket insert the thin narrow screw-driver and wring out a fixing short mustache on contact and for a wire take contact from the socket.
6. From a back part of the socket insert contacts of a new rekey of a tel into the socket and move them before accurate fixing.
7. Further installation is made in the sequence, the return to removal.