Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
- 11. Coupling and power shafts
   11.2. General information
   + 11.3. Check and replacement of a clutch plate
   - 11.4. Release bearing
      11.4.2. Check
      11.4.3. Installation
   + 11.5. Main cylinder of coupling
   + 11.6. Working cylinder of coupling
   11.7. Removal of air from hydraulic system of coupling
   11.8. Starting switch of coupling
   + 11.9. Hinge of Equal Angular Speeds (HEAS)
   + 11:10. Replacement of protective covers and repair of hinges of equal angular speeds
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment




11.4.3. Installation

PERFORMANCE ORDER
1. Apply a thin film of high-temperature lubricant on the internal surface of the release bearing, a vent of a main shaft and the directing plug of the release bearing.
2. Apply a thin film of high-temperature lubricant on the places of a fork of switching off of coupling contacting to the release bearing, a hairpin with a spherical tip and a pusher.
3. Install the release bearing on a coupling switching off fork.
4. Install the release bearing on the directing plug in a forward part of the transmission. At the same time pass a fork of switching off of coupling through an opening in a coupling case. Establish a fork of switching off of coupling on a hairpin with a spherical tip before fixing it.
5. Apply a thin film of high-temperature lubricant on the forward party of the release bearing contacting to a diaphragm spring of a press disk.
6. Further installation is made in the sequence, the return to removal.