Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
- 11. Coupling and power shafts
   11.2. General information
   + 11.3. Check and replacement of a clutch plate
   + 11.4. Release bearing
   + 11.5. Main cylinder of coupling
   + 11.6. Working cylinder of coupling
   11.7. Removal of air from hydraulic system of coupling
   11.8. Starting switch of coupling
   + 11.9. Hinge of Equal Angular Speeds (HEAS)
   - 11:10. Replacement of protective covers and repair of hinges of equal angular speeds
      - 11.10.1. Models with the engine 5S-FE
         11.10.1.2. Check
         11.10.1.3. Assembly
      + 11.10.2. Models with the engine 3VZ-FE or 1MZ-FE
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment




11.10.1.3. Assembly

GENERAL INFORMATION

Power shafts on models with engines 5S-FE
 
1 – antidust cap;
2 – blooming ring;
3 – bearing;
4 – intermediate shaft;
5 – collars of fastening of protective covers;
6 – trekhplechy hinge;
7 – protective cover;
8 – protective cover;
9 – lock ring;
10 – collars of fastening of protective covers;
11 – power shaft;
12 – draft of the stabilizer of cross stability;
13 – lock-nut;
14 – forelock;
15 – tip of steering draft;
16 – left power shaft;
17 – lock ring;
18 – lock ring;
19 – bolt of fastening of the intermediate bearing;
20 – right power shaft;
21 – protection of a forward wing

Measurement of length of a power shaft on models with engines 5S-FE


PERFORMANCE ORDER
1. Wrap up a shlitsevy part of a power shaft an adhesive tape and establish protective covers of hinges of equal angular speeds on a power shaft.
2. Remove an adhesive tape from shlits of a power shaft and install the three-humeral hinge on a power shaft and fix it by a lock ring.
3. Fill with lubricant the case of the hinge of equal angular speeds and grease the three-humeral hinge.
4. Install the three-humeral hinge with a power shaft in the hinge case.
5. Establish a new protective cover on a power shaft so that the flange of a protective cover was established in flutes of a power shaft.
6. Moving the three-humeral hinge in the hinge case, establish the required length of a power shaft (see rice. Measurement of length of a power shaft on models with engines 5S-FE).
7. Using the screw-driver, let out the air from under a protective cover.
8. Fix a cover by a collar.